![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
After the LED flexible lamp strip has been heavily tested and turned off, there will still be no light. The reasons are as follows:
1. The packaging protection of the LED flexible lamp strip is not perfect, which causes the lamp bead to be damaged by the impact during transportation.
2. The soldering point of the LED flexible lamp strip has a phenomenon of virtual soldering, and the vibration during the transportation causes the solder joint to fall off and the light strip is not bright.
3, LED flexible lamp with less solder, the solder joints are easy to fall off
4. The quality of the LED flexible lamp with solder is not good. The soldering point of the LED flexible lamp strip is prone to brittle cracking and falling off during the bending process.
5. When the LED flexible lamp strip is installed, the bending angle is too large, causing the LED flexible lamp to be separated from the copper foil and causing the light to be off.
6. The LED flexible lamp strip over-extrudes the product during installation, resulting in damage to the LED flexible lamp with the chip or the solder joint deformation and not brightening.
7. LED flexible lamp with circuit board solder mask is too thick, solder and circuit board can not be completely fused together during soldering, it is also a kind of virtual soldering phenomenon.
8. The LED flexible lamp strip can not be twisted during installation. If it is twisted, the solder joint of the LED flexible strip will fall off and cause no light.
The mirror wire are used for car recorder and car backing radar.
What does our product include?
| 1 | JST wire harness |
| FH-----0.5mm ZH-----1.5mm | |
| SH-----1.0mm PH-----2.0mm | |
| GH-----1.25mm VH-----3.96mm | |
| EH/XH-----2.5/2.54mm | |
| 2 | Molex wire harness |
| PicoBlade-----1.25mm PicoClasp-----1.0mm | |
| PiciLock------1.0/1.5mm Minifit Jr-----4.2mm | |
| MicoBlade-----2.0mm MicoClasp-----2.0mm | |
| MicoLock-----1.25/2.0mm | |
| 3 | IDC flat ribbon cable |
| Contact material----Copper alloy | |
| Test voltage------500V AC | |
| Current rating-----1A | |
| Cable Technical Data: | |
| Contact Material----Tin plated copper | |
| Isolationswiderstand-->1000MΩ | |
| Insulation Resistance-->1000MΩ | |
| Temperature range----- -40℃.....105℃ | |
| UL Typ---------UL2651,28AWG |
Mirror Wire,Turn Signal Mirror Harness,Mirror Wire Harness,10 Pin Connector Wire Harness
Dongguan YAC Electric Co,. LTD. , https://www.yacentercns.com